Product Introduction
I. KMP-100 series catalysts are high activity and high hydrothermal stability continuous reforming catalysts developed by Kaimai Zibo.
II. KMP-100 catalyst is an economical catalyst with low platinum content.
III. The product appearance is φ 1.6~1.8mm black ball.
Product characteristics
The catalyst uses new catalytic materials, which significantly improves the ability of the catalyst to resist high temperature hydrothermal treatment, slows down the decline of specific surface area, and increases its service life, greatly increasing the economy of the catalyst.
I. The mechanical strength is improved, the wear resistance is good, and the amount of dust generated during circulation and transportation is reduced;
II The regeneration activity can be restored to the freshness level.
Product technical indicators:
| Item | Unit | KMP-100 target | Remark |
| Pt/Al2O3 | m% | 0.3±0.01 | |
| Sn/Al2O3 | m% | 0.2±0.1 | Adjust according to device demand |
| BET surface | ㎡/g | 105±10 | Adjust according to device demand |
| Pile ratio | g/ml |
0.65±0.02 0.59±0.02 |
Adjust according to device demand |
| Crushing strength | N/Each capsule | ≥39 | |
| Wear rate | % | ＜4 | |
| Particle size distribution | Φ1.6～1.8mm | ＞98% | |
| Defect rate | m% | ＜0.5% | |
| Si/ Al2O3 | ppm | ＜200 | |
| Fe/ Al2O3 | ppm | ＜100 |
Scope of application
I. It can be used in all mobile bed alkane dehydrogenation to olefin units.
II. KMP-100 series catalysts are applicable to the dehydrogenation reaction process of isobutane, propane, isobutane and propane.
Product packaging
The special iron drum is sealed and packed, and the inner layer is covered with a cloth bag and a plastic bag, with a net weight of 100kg/barrel, and filled with nitrogen for positive pressure protection.
Precautions for storage, transportation and use
I. Pay attention to waterproof and moisture-proof, and prohibit contact with other chemicals and hydrocarbon substances.
II. Do not drop or roll the iron bucket during handling.
III. The product is delivered in the reduced state, and the catalyst loading should be carried out in sunny days, and the catalyst loading should be as short as possible Contact time of chemical agent and air, after filling
IV. The reactor shall be sealed in time and filled with nitrogen for protection.
V. The start-up shall be carried out in strict accordance with the catalyst start-up manual provided by Zibo Kaimai, and under the guidance of professional technicians when necessary.
